SH2000
82.150 Rev 100315
27
6.14 Pressure Wheel Alignment
A
Moving Pressure Wheel
B
Adjusting Screws
C
Spacers
D
Fixed Pressure Wheel
6.14.1 To check if the Pressure Wheels are in parallel alignment, look through the outfeed
end of the sealer.
6.14.2 The faces of the Pressure Wheels must be parallel and at the same height
(±0.5mm)
6.14.3 To adjust the height, remove the clips from the Pressure Wheel shafts and
reposition one of the Spacers from below to above, or above to below, each of the
Pressure Wheels.
There must always be at least one Spacer above and below each
Pressure Wheel.
6.14.4 To adjust the parallelism of the faces, adjust the two screws (B) under the rear
Bottom Plate that attach the Fixed Pressure Wheel (D). This will have the effect of
tipping the Pressure Wheel towards or away from the Moving Pressure Wheel (A).
6.14.5 Both screws must be tight when the adjustment is complete
A
B
C
D
Touching at top
Touching at bottom
NOTE
SETTING UP
Summary of Contents for Saxon SH 2000
