SH2000
82.150 Rev 100315
30
7.2 Replacing Heater Capsule - HEATING CAPSULE 1
THIS OPERATION MUST BE CARRIED OUT WITH MACHINE COLD
Replacement of Heating Capsule is the reverse of instructions on previous
page, but taking account of the following points:
Note: Thermocouple(s) must be fitted to the capsules located in the
position(s) where they were previously fitted.
7.2.1
The thermocouple must be fully
fitted into its retaining clip, the tip of
the thermocouple must be fully
home into the capsule outlet slot
and must NOT protrude beyond the
edge of the outlet lips. The tip
should be positioned centrally in the
air gap to allow air to pass all
around it.
7.2.2
Check that the connecting pins in
the capsule are firmly fitted into the
corresponding sockets in the heater
manifold.
B Earth connection
D Thermocouple
E Thermocouple inserted in slot. Tip must not be touching metal case.
7.2.3
To reset Capsule height, see ‘Setting Heating Capsule Height’ (see Section
6.12
)
7.2.4
Run Autotune (see
Section 6.6
).
B
D
E
MAINTENANCE
Summary of Contents for Saxon SH 2000
