SH2000
82.150 Rev 100315
33
7.5 Change Pressure Wheels
7.5.1
Pull back tensioner(s) (A) and remove belt(s) (B).
7.5.2
Remove clip (C), washer, shims and spacer(s).
7.5.3
Lift off pressure wheel (D) and replace.
7.5.4
Re-assemble in reverse order. When re-assembled, there must be no vertical
movement of the Pressure Wheel.
7.5.5
Shims must be added (by trial and error) until vertical movement is eliminated.
7.5.6
Clip should not be excessively tight to fit or remove by hand (i.e. without use of
tools).
7.5.7
Check vertical alignment between front and rear pressure wheels.
7.5.8
There are 3 off spacers (E) in each pressure wheel assembly. One of these can be
positioned above or below each pressure wheel to alter the vertical position.
7.5.9
There must always be at least one spacer above and below each pressure wheel.
A
A
B
B
C
C
E
D
E
D
MAINTENANCE
Part No
Description
Quantity
19.3006
Fine Knurl
6mm
19.5006
Plain
6mm
19.4006
Coarse Knurl
6mm
19.6006
Threadform (Pair)
6mm
19.1006
Fine Diamond
6mm
19.9006
Threadform (Single)
6mm
Summary of Contents for Saxon SH 2000
