SH2000
82.150 Rev 100315
34
7.6 Replace Motor or Gearbox
BEFORE UNDERTAKING ANY MAINTENANCE PROCEDURE,
MACHINE MUST BE ISOLATED FROM MAINS SUPPLY.
A
Motor
E
Gearbox bracket
B
Motor fixing screws
F
Gearbox & bracket fixings on outside face
C
Coupling
G
Gearbox
D
Drive pulleys
7.6.1
Motor
7.6.1.1 Open rear cover.
7.6.1.2 Disconnect motor cable from the motor.
7.6.1.3 Slacken screw holding coupling to motor shaft.
7.6.1.4 Remove 4 off motor fixing screws and remove motor from housing.
7.6.1.5 Replace in reverse order.
7.6.2
Gearbox
7.6.2.1 Open front cover.
7.6.2.2 Slacken screw holding coupling to motor shaft.
7.6.2.3 Remove 4 off screws holding gearbox brackets.
7.6.2.4 Remove 4 off screws holding gearbox.
7.6.2.5 Remove gearbox.
7.6.2.6 Remove brackets, drive pulleys & any auxiliary pulleys from gearbox drive shaft.
7.6.2.7 Remove 2 off keys from drive shafts.
7.6.2.8 Replace in reverse order.
7.6.2.9 Align pulleys with timing belts.
7.6.2.10 Make sure all grub screws securing the pulleys are fully tightened.
The main drive pulleys at the bottom of the shafts must have 0.5mm
clearance to the Bottom Plates
NOTE
IMPORTANT
MAINTENANCE
F
A
E
D
C
B
G
Summary of Contents for Saxon SH 2000
