Maintenance Instructions
14.2.13
Panda_4800i PMS_eng.R04 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 103
6.10 Removing and installing oil strainer
Fig. 6.10-1: Ölsieb
1. Place a suitable container underneath.
2. Drain engine oil
3. Unscrew both bolts (1).
4. Remove oil strainer housing (2).
5. Collect old oil in a suitable container and dispose of in
accordance with the environmental regulations.
6. Clean oil strainer with cold cleaning agent or diesel.
Note:
If the oil strainer is deformed or damaged, it must absolutely
be replaced.
Fig. 6.10-2:
absolutely be replaced
Ölsieb mit Anbauteilen
7. Install cleaned or new oil strainer (4) with new gasket (3)
carefully.
8. Screw in both bolts (5) with new copper seals (6) and
tighten.
Tightening torque: 3 – 4 Nm
9. Screw in oil drain plug (7) with new copper seal (8) and
tighten with ring spanner SW 13.
Tightening torque: 12 Nm
Fig. 6.10-3: Öleinfüllverschlussdeckel
10.Release oil filler cap (9) e.g. with a flat wrench (wrench
size: 13 mm) and screw off by hand.
11.
Fill with engine oil.
12.
Pull out oil dipstick (Fig. 47/2) and clean the bottom end
with a clean and fluff-free cloth.
13.
Replace the oil dipstick (Fig. 47/2) and pull it out again.
14.
Check the oil level quantity. The oil level should be just
under the Max. marking.
15.
Only tighten the oil filler cap (9
) by hand
(risk of break-
age).
16.
Start engine and check for leaks.
Copyright Greaves-Farymann Diesel GmbH
Summary of Contents for Panda 4800i PMS
