Maintenance Instructions
Seite/Page 112 Panda_4800i PMS_eng.R04 - Kapitel/Chapter 6: Maintenance Instructions
14.2.13
Fig. 6.14.3-4: Impeller
Pull to the impeller with a multigrip pliers of the wave.
Fig. 6.14.3-5: Impeller
Check to the impeller for damage and replace it if necessary.
Before the reinsertion into the housing the impeller should have been lubricated with glycerin or with a non-mineral
oil based lubricant e.g. silicone spray.
Notice!:
Mark the impeller, to make sure that these is used in the correct
position at re-installation. This is very important, because the
impeller can dissolve otherwise very fast.
Fig. 6.14.3-6: Gasket
The impeller is attached to the pump wave if the old impeller is
used, pay attention to the before attached marking).
Fastening the cover and use a new gasket.
Summary of Contents for Panda 4800i PMS
