B
l u e t o o t h
C
o n t r o l
S
e t
o
p e r a t i n g
m a n u a l
16
3 The Transmitter
Power supply
A 9V block battery is required for operating the transmitter (6F22, not included in the scope of
delivery). No other power supply may be used.
Transmitter view (see Fig. 2, page 1)
●
Left joystick (3)
for control of output M1 and M2 of the receiver When the joystick is moved upward, the motor
M1 turns in one direction, when the joystick is moved downward it turns in the other direction.
The speed of the motor changes the more the joystick is deflected. The same applies to the
movement to the left or right for motor M2.
●
Right joystick (6)
for control of output M3 and the servo output of the receiver. To control output M3, move the
joystick up and down. If the joystick is moved to the left or right, then the servo moves from
the centre position in the respective direction. With this an excellent steering can be built for
a vehicle. Assembly example Fig. 6.
●
LED (4)
Operating display is lit continuously when the transmitter is switched on and is connected
with a receiver.
Flash codes
Flashes slowly, approx. 1x per second
Receiver is not connected
Flashes rapidly, approx. 4x per second
Pairing mode, receiver searches for a
transmitter
Flashes approx. 2x per second
Power supply too low, battery must be
replaced soon.
