19
B
l u e t o o t h
C
o n t r o l
S
e t
o
p e r a t i n g
m a n u a l
●
Servo connection (12)
Connection for the fischertechnik servo (item no. 132292) see also Fig. 5. Pay attention to the correct
poles when connecting the servo. It can be recognized in the shape of the plug.
●
Trimmer for servo (11)
Setting of the centre position of the servo. By turning on the trimmer the steering of the model,
for example, can be set so that it moves exactly straight forward if the joystick for the steering
is in the centre position.
●
Motor connections M1 - M3 (15, 14, 13)
Here the motors M1 to M3 are connected via plugs. When the direction of rotation of a motor
should be changed, simply switch the plugs of a motor.
●
Select button (16)
Pressing long (approx 3 sec.): Pairing mode is activated. The LED flashes rapidly (approx. 4x per
sec.). Pairing mode remains active for approx. 30 sec. If during this time there is no receiver found
it is switched off again. During the 30 sec. the pairing mode can be immediately switched off by
briefly pressing the button.
5 Servo
Servo view (see Fig. 6, page 2)
The fischertechnik servo (item no. 132292) is connected to the servo connection of the receiver
Fig. 3, (12).
Note: The servo plug must be plugged in as shown in Fig. 5.
If plugged in incorrectly, the servo does not function.
It is activated by the right joystick of the transmitter and changes its deflection depending on the
position of the joystick. The servo is mainly used for steering vehicles.
