10
INSTALLATION INSTRUCTIONS
Water supply valve
Connecting water
1
Ensure the refrigerator is NOT plugged into a power supply. Locate the water supply
valve for cold water connection (Tee and tap fitting not supplied).
2
Locate the water hose set to complete the water connection installation.
3
Remove cap from water inlet valve at the back of the refrigerator
A
.
4
Connect one end of the water hose set to the water inlet valve
b
.
5
Push the plastic molded end (ferrule) into the water inlet valve. Tighten the compression
nut until it is hand tight, then tighten one additional turn with an adjustable spanner.
6
Connect the other end of the water hose set to the water supply valve
c
. Push the
plastic molded end (ferrule) into the water supply valve, tighten the compression nut
until it is hand tight. Tighten one additional turn with an adjustable spanner.
7
Check the connections, turn on the water supply and check for leaks.
Water inlet valve
Water hose set
Plastic
molded end
B
A
c