13
INSTALLATION INSTRUCTIONS
Before you start using the Ice & Water or Automatic Ice function
Before first use, you need to flush water through the filter to remove impurities or
trapped air in the water tank and filter system.
For Ice & Water
●
●
Press the water dispenser pad to dispense 1gal (4L) of water.
– Wait for 2 minutes before dispensing again.
●
●
Dispense 1gal (4L) of water and then wait for another 2 minutes.
– There may be carbon residue dispensed together with water. This is not harmful,
and is normal during the flushing process.
●
●
Dispense another 1gal (4L) of water.
– This prevents excessive dripping of water from your dispenser.
●
●
There may be a few drips of water coming out of the dispenser for a few days after
installation. This is to clear the remaining trapped air in the dispenser.
●
●
Ensure your refrigerator has cooled for at least 2 hours before use.
For Automatic ice model
1
Press to turn on the ice maker. The light above the button will illuminate indicating
the ice maker is on.
2
Press , and together for 4 seconds then close the doors. The ice tray will empty
the water into the bin below. The ice tray will only empty after the doors are closed.
3
Repeat step
2
to remove dust in the ice tray collected during manufacture
and transport.
4
Empty the water, dry the bin and return it correctly.
5
Once your ice maker is turned on the first bin of ice may be discolored. This is not
harmful and normal during the flushing process. Discard the first full bin of ice made.
Your ice maker is now ready for use.
Note: The performance of your water filter will increase with use, reaching optimum
performance after two to three full bins of ice.
Water dispenser
