26
IMPORTANT!
●
●
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
4
Secure side bracket forks by
tightening side screws (
C
).
Note:
– For depth adjustment, loosen the side screws (4),
adjust the panels and then retighten once satisfied.
– Further adjustment of door panels can be achieved
by removing door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
5
Loosely install locking bracket into the pocket on the
underside of the door using a M8 stud (
D
).
– Slide the locking bracket out until it touches the back
of the door panel. Fully tighten the M8 stud.
– Screw in place using a #8x16 screw through one
of the three slotted holes.
C
B
A
D
Adjust the door panels
1
Place a ruler on the front of the appliance to check
flushness top and bottom, left and right.
– Ensure the gap between the top of the door panel
and the top cabinetry is not more than 1/4" (7mm).
– To reduce this gap, raise the appliance by turning all
four adjustment nuts the same number of turns.
2
Each door panel has full axis adjustment to ensure
flushness with adjacent walls. To adjust the height
of the panel, turn the stud clockwise to raise or
counter-clockwise to lower the door panel (
A
).
3
Once satisfied with the alignment, secure M8 studs
with M8 washer and M8 nut (
B
). The top of the stud
must remain below the top face of the door panel.
Tools
FPA spanner
Hex key
Cross-head screwdriver
Powered driver (optional)
Ruler
#8 x 16
M
ush W
asher
Twin T
hr
ead
Philips S
cr
ew
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8x16 mush washer screw
(1)
!9
DOOR PANEL INSTALLATION — STAINLESS STEEL
