31
Adjust the door panels
1
Place a ruler on the front of the appliance to check flushness top
and bottom, left and right.
– Ensure the gap between the top of the door panel and the
top cabinetry is not more than 1/4" (7mm).
– To reduce this gap, raise the appliance by turning all four
adjustment nuts the same number of turns.
IMPORTANT!
●
●
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
Tools
FPA spanner
Hex key
Cross-head screwdriver
Ruler
#8 x 16
M
ush W
asher
Twin T
hr
ead
Philips S
cr
ew
#8 x 16
Mush Washer
Twin Thread
Philips Screw
#8x16 mush washer screw
(1)
@0
DOOR PANEL INSTALLATION — CUSTOM
2
Each door panel has full axis adjustment to ensure
flushness with adjacent walls. To adjust the height of
the panel, turn the stud clockwise to raise or counter-
clockwise to lower the door panel (
A
).
3
Once satisfied with the alignment, secure M8 studs with
M8 washer and M8 nut (
B
). The top of the stud must
remain below the top face of the door panel.
4
Secure side bracket forks by
tightening side screws (
C
).
Repeat for all door panels.
Note:
– For depth adjustment,
loosen the side screws (10),
adjust the panels and then
retighten once satisfied.
– Further adjustment of door
panels can be achieved by
removing door panels then
loosening the fixing screws
for the hanging bracket and
moving the bracket sideways
to suit.
5
Loosely install locking bracket
into the pocket on the underside
of the door using a M8 stud (
D
).
– Slide the locking bracket out
until it touches the back of
the door panel. Fully tighten the M8 stud.
– Screw in place using a #8x16 screw through one
of the three slotted holes.
C
B
A
D
