32
2
Each door panel has full axis adjustment to ensure flushness
with adjacent walls. To adjust the height of the panel, turn the
stud clockwise to raise or counter-clockwise to lower the door
panel (
A
).
3
Once satisfied with the alignment, secure M8 studs with M8
washer and M8 nut (
B
). The top of the stud must remain below
the top face of the door panel.
Adjust the door panels
1
Place a ruler on the front of the appliance to check flushness top
and bottom, left and right.
– Ensure the gap between the top of the door panel and the
top cabinetry is not more than 7mm.
– To reduce this gap, raise the appliance by turning all four
adjustment nuts the same number of turns.
IMPORTANT!
●
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
B
A
B
Door panel
attachment
kit
#8 x 16
M
ush W
asher
Twin T
hr
ead
Philips S
cr
ew
#8 x 16
Mush Washer
Twin Thread
Philips Screw
8x16 mush washer screw
(1)
Tools
FPA spanner
Hex key
Cross-head screwdriver
Ruler
@0
DOOR PANEL INSTALLATION — CUSTOM
4
Secure side bracket forks by
tightening side screws (
C
).
Note:
– For depth adjustment, loosen the side screws (4), adjust the
panels and then retighten once satisfied.
– Further adjustment of door panels can be achieved
by removing door panels then loosening the fixing screws for
the hanging bracket and moving the bracket sideways to suit.
5
Loosely install locking bracket into the pocket on the underside of
the door using a M8 stud (
D
).
– Slide the locking bracket out until it touches the back
of the door panel.
– Screw in place using a #8x16 screw through one
of the three slotted holes. Fully tighten the M8 stud.
C
D
