18
Internal box
A
Anti tip
bracket kit
Anti-tip bracket
(1)
Masonry plug
(4)
#10x40
Pan Head
Philips S
cr
ew
#10x40
Pan Head
Philips S
cr
ew
#10x40 cross-head screw
(4)
Tools
Cross-head screwdriver
Powered driver
(with drill bit)
Pencil
IMPORTANT!
●
The anti-tip bracket and fittings supplied must be fitted to the wall
of the finished enclosure to withstand 100kg load.
●
Ensure that anti-tip bracket is installed correctly to prevent the
appliance tipping forward when door is open.
●
Ensure the bracket is secured to structural beams or wall studs
nearest to the center of the alcove.
WARNING!
Read the following before fastening with masonry plugs and/or screws:
●
Ensure the screws avoid electrical, gas and water conduits.
●
Ensure lightweight masonry material such as cinder block
and new concrete (no curing time) are not used in installation.
●
Do not use metallic materials that may corrode, stain and/or
damage the enclosure.
!3
CAVITY PREPARATION
Attach anti-tip bracket
1
Project horizontally from the bottom edge of the finished enclosure
towards the center of the back wall.
– For 2134mm cavity installation — measure 164mm downward from the
projection line (
A
).
– For 2032mm cavity installation — measure 62mm downward from the
projection line (
B
).
This will locate the contact surface between the bracket and appliance.
2
Mark the location for placement of the anti-tip bracket. Place the bracket
so the top edge of the contact surface aligns with the mark (
C
).
3
Mark the locations of the screw holes on the wall based on the most
central wall stud (
D
).
4
Drill screw holes to the marked locations.
5
For wooden / plaster board wall installation:
– Fix the bracket to the wall with #10x40 pan head cross-head screws,
and screw tightly (
E
).
6
For solid wall installation:
– Hammer masonry plugs into the wall until flush.
– Fix the bracket to the wall with #10x40 pan head cross-head screws
(4x), and screw tightly (
F
).
A
B
Anti-tip
bracket
E
F
C
D
If the minimum 60mm
overlap cannot be
achieved, install a solid
spacer to the wall stud
behind the bracket.
IMPORTANT!
When positioning the appliance
in the cabinetry, ensure that the
anti-tip bracket overlaps the
refrigerator by a minimum 60mm
for a secure hold.
.
60mm overlap
Anti-tip
bracket
60mm overlap
Spacer
Anti-tip
bracket
