24
B
Remove hanging brackets
1
Remove the M8 washers and M8 nuts from the
M8 studs at the top the door (
A
). Keep the
washers and nuts to reuse later.
2
Remove the hanging bracket from the top of
each door and set aside (
B
) for later installation.
A
IMPORTANT!
●
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
●
Ensure to protect the finish of the Stainless steel door panels.
●
For non-water dispensing door panels: Leave the protective film on the panels when hanging and remove the film only when installation is complete.
E
Attach the door and drawer handles (
C
)
3
Remove the plastic plugs from the handle
holes (4 per each door panel).
4
Align the handle holes with the door panel
holes and secure with M5x25 pan head
socket screws (4 per each door panel).
D
Attach the hanging brackets (
D
)
5
Align the bracket to the holes and secure
with M5x14 mush cross-head SS screws (12).
C
C
Attach side brackets and straps (
E
)
6
Align the brackets and straps to the holes on
the side of the panel and secure with M5x14
mush cross-head SS screws (12).
D
!9
DOOR PANEL INSTALLATION — STAINLESS STEEL
Internal box
B
Door panel
attachment kit
Side bracket
(10)
Side strap
(10)
Door handle kit
M5 x 25
Pan Head
Socket S
cr
ew
M5 x 25
Pan Head
Socket S
cr
ew
M5x25 pan head socket
screw (8)
Door panel set
M5 x 14
M
ush Head
SS
Philips S
cr
ew
M5 x 14
M
ush Head
SS
Philips S
cr
ew
M5x14 mush cross-head
(SS) screw (24)
Tools
Hex key
FPA spanner
Cross-head screwdriver
Torx screwdriver
