Fisher & Paykel DH9060P, Installation Manual

9

COMPLETE INSTALLATION

Test cycle

Ensure the test cycle is completed before you dry any items in your dryer. The test cycle is to 
check that your dryer is installed correctly and that it is functioning properly prior to use.

1

Press 

POWER

 to activate your dryer.

3

Press 

 , the drum will start rotating.

Observe the dryer for any problems. 
The dryer will beep and display any faults on 
the screen. If there are any problems, refer to 
your user guide.
At the completion of the cycle, open 
the door and check that there is warmth 
inside the dryer. This indicates the dryer 
is operating normally.

Select the 

TIME DRY

 cycle for 30 minutes. 

Ensure the drum is empty and the door 
is closed (you will hear it click shut).

2

If there are any problems, you must address these before proceeding with normal use. The 
dryer will automatically turn off at the end of the cycle if there are no problems.

z

Turn on the water and check all hose connections for leaks. Make sure there are no kinks in 
the hose(s). Check the hose connections for leaks again after 24 hours.

z

Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.

z

Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.

TO BE COMPLETED BY THE INSTALLER

Is the dryer correctly levelled, and are the cabinet corners clear of the floor 
and walls?

Is the drain hose attached to the correct outlet and hooked into a standpipe or tub?

Has the water inlet been connected correctly?

Are the water tank, condenser filter, foam filter and lint filter correctly in place?

Has the power cord been connected to an appropriate power supply and the power 
turned on?

Have you performed the test cycle?