11
INSTALLATION INSTRUCTIONS
What to do if your product is unstable
5
Gently push the refrigerator back until the
rear rollers contact the floor.
– Measure the gap under the front foot,
which has come off the floor.
– Obtain some solid packing material
(hardwood, plastic, etc) which fits firmly
into the gap under the foot.
Note: do not use metallic materials that may
corrode, stain and/or damage floor coverings.
6
Wind both front feet up and roll the product
out of position.
– Place the packing material in the location
diagonally opposite the front roller that
lifts off the floor.
– Make sure the packing material stays in place
when the product is pushed back into position.
– Ideally, the packing material is large enough
to rest against the back wall so as to
prevent it from moving when the cabinet
is pushed into position.
7
Roll the refrigerator back into position and
adjust front feet as per step
3
. (Check alignment
and door closing action are satisfactory).
– Make small adjustments to front feet
where necessary.
– Check that the product is stable
(all four feet are on the floor).
If not, repeat steps
4
c
,
5
and
6
.
This foot lifts off the floor when
top front is gently pushed back
Example only
Unlevel floor
Unstable refrigerator
Wall behind refrigerator
For example: if this foot lifts off the floor when
pushing gently on the top front of the refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Stabilising your refrigerator
