517804 D
29
5.6 LCD
Display
When the PC door is opened the backlight of the display will turn off and the functions will not operate i.e.: the
water dispenser will not work and temperature setting etc cannot be altered.
However, if the door is left open for 5 minutes the interior light will turn off and the alarm will sound at this point
the display will start working and all functions will be operative.
Bin lever in down position - when in this position
icemaker will not rotate/harvest.
5.7 Data
Download
To place the product into download mode, press and hold the
MENU
button, then press the
UP
button for four
seconds, then press
DOWN
button.
Once the product is in a download mode, either of the LEDs can be used. Place the download pen towards
the LEDs and start the download. The display will have the letters “dl” signifying product is in a download
mode.
Diagram H
6 WATER
DISPENSER
6.1
Pressure Dispensing Pad
This pad is located at the rear of the dispensing area, and used to dispense water. Water can be dispensed
using a measured fill option on the display, or free flow. The display will light up and the water fill icon will
appear when the water is dispensed.
The dispenser will not operate while the PC door is open.
6.2 Initial
Use
Press the glass or container into the pressure-dispensing pad.
Note: Pressing very hard against the water dispensing pad will NOT make the water dispenser operate
any faster or produce greater quantities of water.
Initially allow approximately one-minute delay from when the pressure-dispensing pad is pushed until the
water is dispensed. While the tank is filling no water sign will appear.
It is important to flush the tank discarding around 3 litres of water immediately after the first fill. This may also
be necessary after extended periods of non-use.
6.3
Measured Fill Use (Products before January 2009)
Select the desired amount to be dispensed.
Activate the pressure-dispensing pad to start dispensing.
Water flow will stop when either the pre-selected amount has been dispensed, or the dispensing pad is
released.
During measured fill, the amount of water dispensed will be counted and displayed on the screen.
