104921 issue A
ECN 06 037
Designer Series Wall Canopy
80325 – EC90 DXV1 (SS NZ/AUS)
80326 – EC90 DMV1 (IR NZ/AUS)
80387 – EC90 DXV1 (SS EU)
88832 – EC90 DXV2 (SS UK)
Please note product may vary slightly from the picture.
Please read the entire instructions before installing the canopy.
INSTALLATION INSTRUCTIONS
PRE-INSTALLATION
Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.
IMPORTANT
•
Please read the entire instructions before installing the canopy hood
•
Always switch the power off prior to installation, servicing or cleaning the canopy hood.
•
Never use the canopy hood without the filters.
•
Stainless steel is very easily damaged during installation if abraded or knocked by tools.
•
A power outlet should be within 750mm of the motor assembly and can be either on the wall,
behind the chimney or in the ceiling.
•
To comply to electrical safety regulations this canopy must be plugged into a socket near the
appliance. The socket must be accessible and enable the end user to isolate the canopy from the
power for the purpose of internal cleaning or maintenance.
Ducting accessories are not supplied. All ducting must comply with local requirements and building
codes.
All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety, this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.
lbs
The canopy hood is heavy please ensure adequate care when installing the canopy
hood to prevent personal injury.
The canopy hood must be installed onto a solid wall, stud, beam or truss. Weight of
product 22.2 kg.
CONTENTS
Contents of packaging
Equipment required
Optional accessories
1 x canopy hood
Electric drill
Charcoal filter
103821
2 x chimney pieces with bracket Screwdriver
Light
bulb
104467
1 x installation instructions
Duct tape
Chimney ext (10’) SS
1740
3 x filter (part number 104660)
Jig saw
Chimney ext (12’) SS
Installation kit (part number 104834)
Ladder
Chimney ext (10’) IR
2 x 12 x 2” screw
Ducting
Recirculation kit
1744
2 x cup washer
Tape measure
3 x 8 x 1.25” screw
Drill bits
1 x wall anchor
Spirit level
4 x 6 x ¼” self tapping screw
HEIGHT OF CANOPYHOOD
C
FILTER SURFACE
HOB TOP
B
A
A=600 min (electric cook top)
A=650 min (gas cook top)
B=225 mm
C=260 mm
•
The canopy hood is designed for 2440mm
high ceilings.
•
The chimney is telescopic and is designed for
hood installations between 650 to 750mm
above the cooking surface.
•
Ascertain the desired installation height of the
canopy hood.
•
Any installation above 750mm will
compromise the extraction performance.
•
The air outlet from the motor requires
150mm round ducting which requires 170mm
diameter hole in the ceiling.
CONTROL PANEL
Delay switch: Canopy hood will remain on a
low, mid or high speed for five minutes to clear
away all residual cooking odours before
switching off automatically
.
I
I I
I I I
Fan On/Off
Mid Speed
High Speed Delay Switch
Light On/Off
