12
WARNING!
●
●
This product is heavy and requires two persons for installation.
●
●
Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes and standards.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1
Preparing for installation:
Before installing your ventilation hood:
●
●
Please read the instructions carefully.
●
●
Unpack the ventilation hood.
●
●
Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate
match the voltage and frequency of the installation site.
●
●
Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes etc
●
●
The ventilation hood surfaces can be damaged during installation if grazed or
knocked by tools. Please take care to protect the surfaces during installation.
●
●
Protect the cooktop surface with cardboard, or the like, to prevent damage
occurring whilst the ventilation hood is being installed above.
●
●
Temporarily mark the height of the bottom of the ventilation hood and the
center of the cooktop on the wall according to the information given in the
‘Installation instructions – Height of ventilation hood’ section.
●
●
The wall used for mounting the ventilation hood should have sufficient strength
and a flat surface.
2
Attach chimney brackets and ventilation hood mounting screws to the wall
●
●
Attach the chimney bracket and upper
chimney bracket (if using the upper
chimney) in the locations shown in Fig.2
(refer to page 13) and Fig.3 (refer to
page 14). Use the 1 3/16” (30 mm) screws
(and expansion plugs if attaching
to masonry).
●
●
Attach the upper ventilation hood
mounting screws in the locations
shown in Fig.2 (refer to page 13) and
Fig.3 (refer to page 14). Using the 1 3/16”
(30 mm) screws (and expansion plugs
if attaching to masonry). Ensure that
there is a 3/32” (2 mm) gap between the
screw head and the wall (Fig.1).
INSTALLATION INSTRUCTIONS
Fig.1
3/32” (2 mm)
