Installation
1.
Preparing for installation:
Before installing your rangehood:
• Please read the instructions carefully.
• Unpack the rangehood and check that all functions are working.
• Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and frequency
at the installation site.
• Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc.
• The stainless steel and glass surfaces of the rangehood are very easily damaged during installation if grazed or
knocked by tools. Please take care to protect the surfaces during installation.
• Protect the cooktop surface below with cardboard, or the like, to prevent damage occurring whilst the rangehood
is being installed above.
• Temporarily mark the height of the bottom of the rangehood and the centre of the cooktop on the wall according
to the information given in the ‘Installation instructions
◦ Height of rangehood’ section.
• The wall used for mounting the rangehood should have sufficient strength and a flat surface.
2.
Attach chimney brackets and hood mounting
screws
• Attach the chimney bracket and upper chimney
bracket (if using the upper chimney) in the
locations shown in Fig.2 and 3. Use the 30 mm
screws and expansion plugs if attaching to
masonry.
• Attach the upper hood mounting screws in the
locations shown in Fig.2 and 3. Use the 30 mm
screws and expansion plugs if attaching to
masonry. Ensure that there is a 2 mm gap
between the screw head and the wall – see
Fig.1.
Fig. 1
https://producthelp.fisherpaykel.com/au/Cook/Rangehoods/Canopy/HC90DCXB3/User_Guide_HC90DCXB3/03_Installation_instructions
Updated: Wed, 06 Mar 2019 11:36:04 GMT
Powered by
8
