7
Installation instructions
Setting your hood to recirculate
Note: an additional charcoal filter (fig.7) is required to
be fitted when setting the hood to recirculation mode.
1
Remove the grease filters.
2
Locate the lever positioned on the motor
casing above the left hand light fitting (fig.8).
The factory default setting for the lever is to the
‘ducted’ position which is required for externally
ducted installations.
3
Slide the lever across to the right hand side
(fig.9) ensuring the lever is sitting beyond the
moulded catch. This redirects the air back into
the kitchen via the front air vent.
4
Fit the charcoal filter onto the clips located in
the centre of the motor casing grill (fig.10).
5
Turn the charcoal filter to clockwise to lock
the filter into position on the clips.
6
The hood is now set to recirculation mode.
The charcoal filter is a disposable item and it
is recommended to replace every 3 – 6 months
depending on use.
Fig.12 Hook the charcoal filter onto the locking
clips and turn it clockwise.
Fig.13 Charcoal filter in locked position.
Fig.7 Charcoal filter required.
Fig.8 Lever set to external ducting position.
Fig.10 Locking clips on motor casing.
Fig.11 Attaching the charcoal filter.
Ducted Recirculate
Fig.9 Lever set to recirculating position.
Ducted Recirculate
