34
If Your Intuitive™ Beeps For Help
“I am not getting any WATER”
The taps have not been turned on.
Inlet hose screens may be blocked.
The hoses may be kinked (refer to page 5).
The drain hose is too low or the drain hose is pushed into the standpipe too far and the water
is siphoning out of the machine. (See Installations Instructions page 4).
The flow rate of the supply water is too slow.
“I am OVERLOADED”
The machine is overloaded and can not agitate.
Ensure the machine is stationary.
Select a higher water level or remove items until the remaining ones can move freely.
Check the machine is not siphoning (refer to page 4).
“I have TOO MANY SUDS”
The machine has a suds build-up. (Too much detergent may have been used for the amount
of soil in the load).
Wait for suds to dissolve (about 20 minutes).
Rinse clothes using a deep rinse, or run through another cycle.
“I can’t LOCK THE LID”
Make sure the lid is closed.
Press
START PAUSE
(Refer to page 12)
If the symptom persists call your Fisher and Paykel Dealer or Authorised Service Centre.
Single Beep Every Second and...
“I need service” message and fault number
1
Turn your machine off at the wall.
2
Wait 1 minute and turn it back on.
3
Check the machine is level.
4
Remove load and retry.
5
Put through a Deep Rinse and Spin.
6
If the fault re-occurs repeat Step 1.
If the machine still will not work call your Fisher & Paykel Dealer or Authorised Service Agent
to arrange service. (Refer to page 38).
Summary of Contents for Intuitive eco IW512
Page 39: ......