Service Manual 547226: OB30
December 2012
62
7.14
Oven Lamp Assembly
Location: Rear corners and top, front of the oven cavity
For Rear Lamp Assemblies
Removal
1. Follow the general servicing instructions for components in
the back panel area. (refer to Section 7.3)
2. Remove the lamp cover and bulb. (refer to Section 7.13)
3. Remove the lamp body retaining screws and the lamp
holder retaining screws.
4. Disconnect the lamp assembly wires at the connectors in
the back panel area.
5. Pull the lamp assembly wires out through the oven cavity.
Note: String can be tied on the end of the light assembly wires to aid in feeding the
new wires back through the holes in the side insulation panel.
Reassembly
1. Feed the new wire connectors back through the hole in the side insulation panel.
2. Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)
Retaining
Screws
Fig 7.14
Summary of Contents for OB30DDEPX1
