30
Care and cleaning
Sliding shelf supports
The telescopic sliding shelf supports make it safer and easier to insert and remove the
oven shelves and trays. They stop when they are pulled out to the maximum position.
Wipe the supports with a damp cloth and a mild detergent only. Do not wash them in the
dishwasher, immerse them in soapy water, or use oven cleaner on them.
To remove the sliding shelf supports:
1
Remove the side racks by unscrewing the fixing screws (Fig. 26).
2
Lay down the sliding shelf support and side racks, with the sliding shelf support
underneath.
3
Find the safety locks. These are the tabs that clip over the wire of the side rack (arrow 1 in
Fig. 29).
4
Pull the safety locks away from the wire to release the wire (arrow 2 in Fig. 29).
To re-fit the sliding shelf support onto the side racks:
1
Screw the side rack onto the oven wall.
2
Fit the sliding shelf support onto the top wire of a rack and press (Fig. 30). You will hear a
click as the safety locks clip over the wire.
Important!
When fitting the sliding shelf supports, make sure that you fit:
the slides to the top wire of a rack. They do not fit on the lower wire.
the slides so that they run out towards the oven door, as shown in Fig. 30.
both sides of each pair of shelf slides.
both sides on the same level. Note: you cannot fit the sliding shelf supports to the top shelf
position.
Fig.29 Removing the sliding shelf supports
Fig.30 Refi tting the sliding shelf supports
1
2
1
Summary of Contents for OR60 models
