• DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
• WARNING – connect to potable water supply only.
• DO NOT install on line pressure above 119 psi (827 kPa) or below 22 psi (150 kPa).
• DO NOT use on hot water supply (100°F [38°C max.]).
• DO NOT cut any length of tube shorter than 8” (200 mm).
• DO NOT install near electrical wires or water pipes that will be in the path of drilling when
selecting the location of filter system.
• DO NOT mount filter in such a position so that it will be struck by other items, such
as wastebaskets, etc.
• DO NOT install the filter or any water tubing in direct sunlight as prolonged exposure to light can
weaken plastic components.
• DO NOT install in a location that is susceptible to freezing temperatures as damage to the
housing could occur.
• DO NOT screw filter to the refrigerator.
• DO NOT install the filter or any water tubing in high temperature areas eg in a ceiling cavity.
• AVOID contamination of pipes during installation.
• DO NOT use copper tubing. The plastic tubing supplied should always be used.
• DO NOT continuously dispense water for longer than 2 minutes.
Installation Instructions
1. Ensure the refrigerator is NOT plugged into a
power supply.
2. Locate a cold water supply/feed only suitable
for a water connection. Tee and tap fitting is not
supplied.
3. Connect the 8” (200 mm) blue tubing to the
Updated: Tue, 02 Jun 2020 23:55:17 GMT
Powered by
12
