outlet of the PRV (blue collet) and the inlet
connection of the water filter cartridge as shown
in Diagram 1. Gently pull on both ends to
ensure it is locked.
4. Connect the white 1⁄4” (6 mm) tubing to the
outlet of the water filter cartridge as shown in
Diagram 2. Gently pull to ensure it is locked.
5. Measure the required length of tubing to run
from the PRV to the water connection point (no
less than 10” (250 mm)).
6. Cut the tubing making sure the ends are square
and clean.
7. Connect the tubing to the faucet connection
and the base of the PRV (white collet) and then
to the faucet as shown in Diagram 3. Please
note that the faucet connection supplied should
fit most installation situations.
8. Connect one locking key to each side of the
water filter cartridge in between the cartridge
and the locking collet as shown in Diagram 4.
9. To flush the water filter of any trapped air,
harmless carbon fines and to also check for
leaks, aim the end of the tubing into a bucket,
turn isolating faucet on and run at least 10 qt
(10 L) of water through. Once complete, turn
isolating faucet off.
10. Locate desired position for water filter noting
carefully the following points:
• It is recommended to fit the water filter in
a vertical orientation with the water filter
head at the top. This will minimize water
leakage when replacing cartridge.
• Ensure the filter is in a convenient
Diagram 1 - PRV Connection
Diagram 2 - Waterline Connection to Refrigerator
Diagram 3 - Faucet Connection
Updated: Tue, 02 Jun 2020 23:55:17 GMT
Powered by
13
