321037
59
5. Using a pair of long noise pliers, insert the pliers into the last two holes drilled, and with the aid
of a screwdriver, rotate the lamp housing anti clockwise. This is to break the foam away from
the back of the lamp housing.
6. Once the old lamp housing is free of the foam, pull it down gently from the roof and cut the
harness from the back of it as close to the housing as possible.
7. Cut and strip the harness, then slide heat shrink over the new lamp harness. Crimp to the
existing harness using butt connectors or by soldering each joint. Insulate the joint with the
heat shrink.
Note:
It is important that good joint connections are made in terminating these two wires, as
failure to do so can produce high temperatures at the joint.
8. Fit the new housing to the liner and test. A small screw may be fitted to each side lug to hold
the housing to the liner if needed.
The freezer compartment lamp housings
don’t
need to be drilled to remove them. Just bend
the lugs back and rotate the housing, following steps 1,2,5,6,7 and 8 above.
Summary of Contents for RF175W
