21
5
Thread the free end of the water hose into the dedicated hole located in the base of the
appliance, through to the back of the appliance (refer to
C
).
6
At the back of the appliance, loosely coil the water hose (~2 – 3 times) and fasten the end
of the hose to the cold water supply (refer to
D
).
Take care not to over-tighten the connection. Turn the isolating faucet on and check that
all connections are dry and free of drips.
7
At the back of your appliance, connect the appliance to the electrical supply (115 VAC,
60 Hz) with the fitted plug and lead, and turn on. Ensure the appliance is connected to its
own isolating switch (refer to
E
).
8
In order to push appliance into correct position:
●
●
Stop midway, reach through base to locate power cord. Pull power cord through the front left
side of the appliance (refer to
F
), tucking it neatly in the left side of the base (refer to
G
).
●
●
Reach through base to locate water hose coil. Tuck coil neatly into front right side of base
(refer to
H
).
IMPORTANT!
Failure to do this can result in running over the hose causing damage and possible
water leaks.
●
●
Push product until doors are in line with the frame. Ensure the appliance is centred.
●
●
Firm contact must be achieved between the appliance and the anti-tip bracket,
2 3/8” min. (60 mm) overlap (refer to
I
).
WARNING!
Failure to follow this instruction can lead to serious injury or death.
D
C
F
E
!0
CONNECT TO WATER AND ELECTRICAL SUPPLY
2 3/8” min.
(60 mm)
overlap
I
Final location
of power cord,
left side of base
G
Final location
of water tube,
right side of base
H
E
