26
!5
HANGING NON-WATER DISPENSING DOOR PANELS
2
Lock top inner panel side screws
to allow opening the doors without
affecting adjustment. (Open the left
door to lock the right screws and
vice versa).
4
Once satisfied with all door panels, secure M8
studs with M8 washer and M8 nut (refer to
B
).
The top of the stud must remain below the top
face of the door panel.
5
Secure side bracket forks by tightening side screws.
Repeat this process for all door panels.
1
Hang all door panels onto M8 studs
and align the side bracket forks onto
the refrigerator door.
●
●
Ensure the forks are positioned
around the body of the side screws
(M5 x 10 pan head Phillips screw).
●
●
Push the product until the door panels
are flush with the front face of the
adjacent cabinetry. Place a ruler on
the front of the product to check
flushness top and bottom, left and
right (refer to drawing below).
●
●
Ensure the gap between the top of
the door panel and the top cabinetry
is no greater than 7 mm. To reduce
this gap, raise the product by turning
all four adjustment nuts the same
number of turns.
IMPORTANT!
Failure to follow these steps can
lead to difficulties in door panel
adjustment and cosmetic cap fitment.
3
All door panels have full axis adjustment to
ensure they are flush with adjacent walls. To
adjust the height of each panel turn clockwise
to raise stud or counter-clockwise to lower
stud (refer to
A
).
B
A
Note: for depth adjustment loosen side screws x4, adjust panels and then retighten
once satisfied.
Note: further adjustment of door panels can be achieved by removing door panels then
loosening the fixing screws for the hanging bracket and moving the bracket sideways to suit.
Place a ruler on the front of
the product to check flushness
top and bottom, left and right.
