15
7
CUSTOM DOOR PANEL DIMENSIONS
The drawings below apply to non-Water dispensing models only (RS36W80(R/L)J/RS36W80(R/L)JC). Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on http://thekitchentools.fisherpaykel.com or http://www.dcsappliances.com/designers-architects/
TOP PANEL – REAR VIEW
Ø 3/32” REF
10x Pilot holes recommended for
bracket attachment.
(Do not penetrate front surface).
15 3/16”
5 1/16”
1 1/8”
3 7/16”
19
3/
8”
21
5/
16”
16 3/8”
All measurements to be made
from top and centerline.
BOTTOM PANEL – REAR VIEW
Cutouts are located in attachment bracket for Fisher & Paykel and DCS handles only.
If locating custom handle in the shaded area shown above, ensure handle screw heads
are countersunk into back of panel to avoid interference with hanging bracket.
Ensure handle is mounted
2 9/16” from edge of panel
to the center – this will avoid
interference with brackets.
1 7/16”
34 1/4”
22”
4
15
/16”
6
15
/16”
24
15
/16”
26
15
/16”
38
5/
8”
30 1/16”
All measurements
to be made from
bottom left corner.
13 11/16”
5 9/16”
Ø 3/32” REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
40”
