31
A
Plastic
Aluminum
For 80” (2032 mm) cavity installation only
2
Measure 4” (102mm) from the top, shorter side trim
and carefully cut using a fine tooth hacksaw to a
length of 76“ (1930mm). Refer to
A
for orientation
of side trim.
Note: ensure cut is straight and square as this is an
exposed surface. Also ensure the plastic part does
not bend as this can cause visual stress marks.
Repeat this process for the remaining side trim.
IMPORTANT!
Before installing your appliance, ensure the dimensions of the finished enclosure are correct for your appliance following the ‘Product and cavity dimensions’ sections.
@0
ATTACH SIDE TRIM BRACKETS – (A) FLEXIBLE SPRING CLIP METHOD
TWO METHODS ARE AVAILABLE FOR ATTACHING SIDE TRIM BRACKETS:
(A) FLEXIBLE SPRING CLIP METHOD – RECOMMENDED METHOD
(B) FIXED SCREW METHOD – METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method A. If method A results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method B).
3
Position 3 side trim brackets onto each side trim.
Note: measure from the top of the trim, with the
shorter lip at the bottom. (Refer to
B
for 80” and
84” bracket locations and trim orientation).
IMPORTANT!
Each bracket has two engagement points for the
side trim to locate. Ensure the trim is engaged in
both points (refer to
C
).
Repeat this process for the remaining side trim.
1
Break off the datum lip to each side
trim bracket and discard.
Repeat for all side trim brackets.
80”
= 9” (229mm)
84”
= 13” (330mm)
80”
= 36” (914mm)
84”
= 40” (1016mm)
80”
= 65” (1651mm)
84”
= 69” (1753mm)
0
B
Discard
Top view of side trim engaged
correctly in side trim bracket
C
Side trim
bracket
Side trim
