29
BEFORE INSTALLATION
Removing pre-installed parts
Moving your appliance
Be careful when tilting the appliance forward/backward. Tape the door shut to prevent
opening while moving the appliance. You need at least two persons to move this appliance.
1
2
3
4
Remove the brackets from the
non-hinge side of the pallet.
Tilt the appliance slightly forward
and insert the hand truck between
pallet and appliance.
Restrain the appliance with
strap and remove the remaining
brackets.
Tilt backward to load the appliance
onto the hand truck and set aside
the pallet.
Push the hand truck to the
installation location.
Hand truck
Strap
Top trim
Disengage one end of the top trim from dual lock
strips on the non-hinge side of the appliance.
Slide the top trim out from the hinge pocket of the
appliance.
Top door extrusion
Unclip the trim caps of the top extrusion carefully
from both ends of the top of the door.
Ensure the magnet remains in place and not
damaged as this will affect the operation of the
appliance.
Toe kick mounting plate
Remove the screws to detach the toe kick mounting
plate.
Air flow divider
Remove the screw to detach the air flow divider.
Set aside all the removed parts to reuse later.
Top grille*
Open the door and remove hinge pocket cover using
a flat head screwdriver in the slot.
Open the water filter hatch on the bottom grille and
unscrew the #8x16 screw.
Remove the bottom grille by unscrewing the #8x16
screws from both ends of the grille.
*Top grille for Refrigerator-Freezer different from illustration.
Bottom grille
The bottom grille is detachable via magnets.
Illustrations may differ from your purchased appliance.
Summary of Contents for RS4621F
Page 2: ......
