30
CAVITY PREPARATION
Anti-tip bracket
assembly kit
Anti-tip bracket (1x)
Masonry plug (4x)
#10x40
Pan Head
Philips S
cr
ew
#10x40
Pan Head
Philips S
cr
ew
#10x40
cross-head screw (4x)
Tools
Cross-head
screwdriver
Powered drill
Pencil
min 7 3/4"
(197mm)
bracket
Floor
A
B
overhead
cabinetry
back wall
PROFILE VIEW
For solid wall installation
Drill holes suitable to the size of the
masonry plugs.
Hammer 10x30mm masonry plugs into
wall until flush. Fix bracket to wall with
#10x40mm cross head screws, and screw
tightly.
For plaster board wall
Fix the anti-tip bracket to the wall with
#10x40mm cross head screws, and screw
tightly with a screwdriver.
1
2
3
4
5
Attaching the anti-tip bracket
Measure the height (
A
) of the attachment
location from the floor to the alcove
return.
z
The height (
A
) must not exceed
84 3/16" (2138mm) to ensure the
appliance does not tip over during
installation.
Mark a horizontal line (
B
) at the back wall.
z
Ensure there is a stud behind the wall.
Place the bracket to the backwall. Align
the undersurface of the bracket along the
marked line.
Mark screw hole locations, and drill screw
holes with powered drill.
When rollng the appliance into the
cabinetry, ensure the anti-tip bracket
overlaps the back edge of the appliance.
z
The bracket must overlap the appliance
by a minimum 7 1/16" (180mm) for a
secure hold.
If minimum 7 1/16" (180mm) overlap
cannot be achieved, install a solid spacer
to the wall stud behind the bracket.
z
Be careful not to run over the power
cord when rolling in the appliance.
Illustrations may differ from your purchased appliance.
Summary of Contents for RS4621F
Page 2: ......
