35
Installation kit
Long trim (2x)
Tools
Cutter
Continue attaching the long trim for
the length of the door panel cutout,
peeling off the film as you go.
Cut-off the excess length of the
bottom end of the long trim.
Repeat all steps on the other side of
door panel cutout.
Attaching the long glass trims
Glass trims are attached to cover the gap between the Stainless steel door panel and glass panel.
DOOR PANEL PREPARATION — WINE CABINET ONLY
3
2
long trim
Do not exceed
pass this line
flange
Peel off a small portion of red
protective film from one end of
the long trim.
1
red protective film
long trim
Attach the peeled portion of the trim
starting from the top of the flange on
one side of the door panel cutout.
z
Ensure the trim does not overlap
the hanging bracket.
Align the trim flush with inside edge
of the flange.
Cut excess length of
trim along this line
hanging bracket
Summary of Contents for RS4621F
Page 2: ......
