37
Water fittings kit
Collet locking
clip (1x)
1/2 BSP Stainless
steel braided hose
with 7/16-24 UNS
thread (1x)
1/4” (6mm) Adaptor
(2x)
POWER AND WATER SUPPLY CONNECTION
Illustrations may differ from your purchased appliance.
Connect one end of a braided water
hose to the water tap.
Flush water through the hose prior to
connection to the appliance to remove
any debris in the hose.
1
braided hose
3
Pull the hose to the front of the
appliance.
6
locking clip
Secure the connection with a locking
clip between the PLV and hose end of
the adaptor.
4
Connect an 1/4" (6mm) adaptor to the
braided hose.
Connecting to water supply
Ensure the door of the appliance is closed before rolling into the cabinetry. Push the appliance carefully towards the front of the cabinetry close enough to allow
access at the back for power and water connection. Ensure an isolating tap is available if water supply is not easily accessible.
Connecting to power supply
At the back of your appliance, connect
the power plug to the power outlet
(115VAC, 60Hz).
z
You will hear a chime sound when
the appliance is powered on.
When powered on for the first time,
your appliance will default to Install
mode.
Once installation is complete,
unlock the control panel and
hold Compartment
button for
four seconds to start cooling.
z
Refer to your ‘User guide’ for more
information on activating your
appliance.
Insert the other end of the braided
hose through a hole at the rear of the
plinth and push all the way to the front
of the appliance.
2
5
Insert the tube end of the adaptor
fully into the PLV at the bottom front
of the appliance.
PLV
Summary of Contents for RS4621F
Page 2: ......
