321023
86
11.5.3
Dispenser Ice Chute Door
1. Remove the dispenser façade (refer to Section 11.5.2).
2. Remove the ice chute assembly (refer to Section 11.5.5).
3. After the ice chute assembly is removed, unsnap the ice chute dispenser door from the assembly.
4. Retain the spring if good, replace if bad.
5. Remove the rubber seal from the door and replace if bad.
6. Reverse the procedure to reassemble.
11.5.4 Dispenser
Light
Socket
1. Remove the dispenser façade (refer to Section 11.5.2).
2. Remove the light bulb.
3. Disconnect the wires to the socket assembly.
4. Squeeze the tabs located by the terminals to release the socket.
5. Reverse the procedure to reassemble.
11.5.5 Dispenser
D/C
Solenoid
1. Remove the dispenser façade (refer to Section 11.5.2).
2. Remove the dispenser water tube clip.
3. Remove the water tube from the assembly collar.
4. Remove the wires from the dispenser light socket.
5. Disconnect the ground wire from the solenoid assembly.
6. Disconnect the wires from the D/C solenoid.
7. Remove the screws holding the D/C solenoid and ice chute assembly.
8. Remove the complete assembly.
9. Rotate to the backside and remove the screws holding the D/C solenoid to the ice chute assembly.
10. Lift the ice chute door to release the plunger from the retainer.
11. Slide the D/C solenoid out of the side of the ice chute assembly.
12. Reverse the procedure to reassemble.
11.5.6 Dispenser
Water
Tube
1. Remove the toe grill and left hinge cap to expose the dispenser water line coupler.
2. Disconnect the water line coupler.
3. Remove the compression nut and sleeve from the door side of the coupler.
4. Remove the dispenser façade (refer to Section 11.5.2).
5. Pull the water tube up from the conduit in the cavity to remove the water tube.
6. Reverse the procedure to reassemble.
Summary of Contents for RX256DT4X1
