42
Ice and water (RX693 / RX594 models only)
Problem
Possible causes
What to do
No indicator lights
are lit on display.
Freezer door is not closed.
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Refrigerator is not
plugged in.
Plug in refrigerator.
Fuse is blown, or circuit
breaker needs to be reset.
Replace any blown fuses.
Check circuit breakers for any tripped
circuits.
Power outage has occurred. Call local power company listing to report
outage.
Refrigerator is in
Sabbath mode.
See ‘Sabbath mode’, see page 14.
Ice or water are not
dispensed when
pads are pressed.
Freezer door is not closed.
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Controls are locked.
See ‘Display and Dispenser Lock’, page 25.
Water tank is filling.
At initial use, there is an approximate
1 – 2 minute delay in dispensing while the
internal water tank is filling.
Ice bin not installed
properly.
Reinstall ice bin (see page 26).
Ice maker has just been
installed or a large amount
of ice has been used.
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Water pressure is too low.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Water filter (if fitted)
is clogged or needs to
be changed.
Change water filter (see page 29).
Troubleshooting
Summary of Contents for RX594
Page 48: ...46 Wiring diagram ...
Page 49: ...47 Wiring diagram ...