- 27 -
4.2
Fault Code Summary
The following are the fault codes that may be displayed. The remedy section of each fault
is the suggested sequence of repair or replacement. If the first suggestion does not
remedy the fault, check the next on the list.
Fault Code 1
Communications Error.
Communications failure between the sensor module and motor control module.
Remedy: (1) Check the continuity of the module interconnecting harness.
(2) Replace the sensor module. (Refer to Section 6.36)
(3) Replace the motor control module. (Refer to Section 6.35)
Fault Code 2
Drum Gap Cannot be Located.
Remedy: (1) Ensure the sensor module is correctly located and clipped into place.
(2) Replace the lens on the sensor module.
(3) Replace the sensor module. (Refer to Section 6.36)
(4) Remove the top deck and clean the drum sensing “bumps” on the
outside of the drum end.
(5) Replace the drum. (Refer to Section 6.30)
Fault Code 3
Drum Stalled.
Remedy: (1) If there is mechanical movement of the drum, but this fault code is
appearing, follow the procedures for fault code 2.
(2) If there is no mechanical movement of the drum, check drum
movement mechanisms: belt, motor and motor harness.
(3) Replace the motor control module. (Refer to Section 6.35)
(4) Replace the motor. (Refer to Section 6.32)
Summary of Contents for Smartload DEGX1
