Fisher & Paykel WALL CANOPY HC60PCHTX1, Installation Instructions And User Manual

6

Installation instructions

1

  Establish the desired height of the 

rangehood above the benchtop according 
to the ‘Installation height requirements’ 
above. Measure this distance from the top of 
the benchtop and, using a spirit level, draw 
a light horizontal line on the wall. Make sure 
that the line can easily be erased or will be 
hidden after installation. This is where the 
bottom of the rangehood will sit (Fig.2).

2

  Mark the position of the rangehood on 

the wall. Using a spirit level, also mark a 
vertical line intersecting the horizontal 
line, (ensuring that the line can easily be 
erased or will be hidden after installation) 
showing the position where the centre of 
the rangehood will be. This is normally over 
the centre of the cooktop (Fig.3).

3

  Remove the grease filters (this is to make 

installation easier). Press inward on the 
catch, found on the handle, and pull the 
filter downward (Fig.4).

4

  Determine location of the fixing “keyholes” 

on the wall. The hood is secured to the wall 
by two “keyholes” located above the motor 
behind the air exit opening. From the point 
where the horizontal and vertical lines 
drawn earlier intercept, use a spirit level 
and pencil and draw another horizontal 
line 290mm above the first horizontal line 
(ensuring that the line can easily be erased 
or the line will be hidden after installation) 
as shown in Fig.5. This now indicates where 
the top of the “fixing keyholes” are.  
Where the vertical line meets the top 
horizontal line (just drawn), measure and 
mark both sides of the vertical line, showing 
where to drill.

Fig.2 Establishing height of rangehood

60 – 75 cm

Fig.3 Marking the position of the rangehood on the wall

Rangehood centre

Benchtop

Bottom of rangehood

Fig.4 Removing the grease filters