Fisher & Paykel WALL CANOPY HC60PCHTX1, Installation Instructions And User Manual

7

Installation  instructions  

5

  Drill holes and secure the rangehood to the 

wall. Depending on the wall type (concrete, 
drywall etc) drill/screw appropriate fittings in 
the two locations just marked. The rangehood 
should now be able to be hung on these bolts/
screws through the two keyholes in the hood.

6

  Create additional means of attachment.  

Keyholes alone are insufficient means of 
attachment. Drill two extra holes in the back 
panel, put screws in with an anchor (if required) 
to ensure proper attachment and fix the 
rangehood by these screws as well, as shown in 
Fig.6. Ensure all fixings are secure.

7

  If ducting externally, assemble and fit ducting 

as per manufacturer’s instruction. 

Optional: If desired, the one-way butterfly valve 
can now be fitted to the exit opening of the 
rangehood by simply snapping the two pieces 
into place.

8

  Test the operation of the rangehood. Plug the 

rangehood in and test its operation on all speed 
levels. This will ensure that any imperfections 
in the installation, such as unwanted sounds or 
lack of suction can be addressed before the flue 
is in place. Over 95% of service calls are a result 
of faulty installation. Please be aware that in the 
event of a service call for a faulty installation, 
you will be charged as this is not covered under 
the manufacturer’s warranty.

Fig.6 Creating additional means of attachment

Keyholes

Extra  

fitting  

holes

290 mm 

Fig.5 Determining location of the two fixing “keyholes”

9

  Position and secure the flue. Secure the top mounting bracket at the highest possible point on 

the ceiling using a single screw through the supplied bracket. 
Ensure all ducting is fitted and electrical connections are secured correctly and switched on. 
Place the bottom part of the flue onto the rangehood and slide the upper flue piece inside the 
lower piece so the tabs “hug” the folded edge of the flue. 
Raise the upper part of the flue to the required height and, using the four screws supplied, secure 
the upper flue to the bracket on the wall.

Installation is now complete.