Lit. No. 72446, Rev. 05
81
November 15, 2020
Other Blades:
Stand in front of blade. While
pushing headgear toward vehicle with left
hand, push pin release handle down to
disengage connecting pins. Make sure that the
connecting pins are fully retracted. If unable
to push headgear from in front of blade, stand
in front of headgear on the driver's side and
push headlamp bracket.
5. Detach all electrical connectors.
NOTE: After each use of the snowplow, reapply
dielectric grease to the electrical plugs to
maintain the protective coating on the terminals.
4.
HS Compact Plows:
Back the vehicle away
from the snowplow. Place the electrical plugs
in the storage boot on the snowplow. The
receivers can be detached from the vehicle,
if desired, by removing the two 1/2" x 4" pins
that attach the receivers to the mounts.
Stop here; blade is detached.
CAUTION
On 2-plug electrical systems, plug covers
shall be used whenever snowplow is
disconnected. Vehicle battery cable is
12V unfused source.
DETACHING SNOWPLOW FROM VEHICLE & STORAGE
1/2" x 4" Pins
with Cotters
Passenger-side
receiver shown.
