4
5
6
• Charge the battery until the power button light
turns green.
It will remain green until you remove the charger cord from
Smart Toy.
• Once the battery is charged, remove the charger cord from the
socket in Smart Toy. Then remove the charger cord from the
USB brick and unplug the USB brick from the wall outlet.
• A fully charged battery should last for about 3½ hours of
continuous play.
Green:
Full Charge
White:
Power ON
Red:
Low Battery
Yellow:
Charging
• Smart Toy’s power is completely OFF in package. To turn power
ON, press and hold the power button for up to 10 seconds until
it lights up. For first time use, Smart Toy will take about a minute
to boot up.
• If Smart Toy is left idle for more than 10 minutes, Smart Toy
enters sleep mode and the power button light turns off. Press
the power button to turn power back ON (and the power button
lights up).
• To turn power completely OFF, press and hold the power button
for up to 10 seconds until the light turns off. When power is
completely OFF, you’ll need to press and hold the power button for
up to 10 seconds until it lights up.
Power Button
• Smart Toy is ready for play right out of the package. For best
performance, fully charge the battery very soon!
1
Open the fasteners on the back of Smart Toy.
2
Plug the smaller end of the charger cord into
Smart Toy’s socket.
3
Plug the other end of the charger cord into a USB brick
(not included).
4
Plug the USB brick into a standard wall outlet. A fully charged
battery may take up to 3 hours.
Hint:
You can also plug the charger cord into the USB port in your
computer. A fully charged battery may take up to 8 hours.
1
2
4
3
USB Brick
(not included)
