FCC Statement
United States Only
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
Three Levels of
Track Layouts!
LEVEL
1
• To build a layout on the bottom level, just place a straight
track (sold separately) through the lowest arch in the tower.
• Use an Elevation Track Pack (sold separately) to
access the second and third levels of the tower.
• Attach a ramp assembly (sold separately)
to the middle arch to reach the ground. Use
supports and straight tracks (sold separately)
to build this elevated assembly.
LEVEL
3
• Attach a ramp assembly to a support (each
sold separately) to reach the third level.
• Use two supports (stacked up) and straight
tracks (each sold separately) to build an
elevated assembly.
LEVEL
2
