Assembly
4
• Position the seat back tube so that the square openings
are upright.
• Fit the seat back tube onto the ends of the base wire.
• Push the seat back tube to be sure it is completely on
the base wires.
Seat Back Tube
Square Openings
5
6
• Insert a #8 x 1.9 cm screw into the inside hole of each handle
and tighten.
• Pull up on the seat back tube to be sure it is secured to the left
and right base wires.
#8 x 1.9 cm Screw – 2
Handle
7
• Fit the pad seat back pocket over the seat back tube.
• Pull and fit the pad seat bottom pocket around the soothing
unit and footrest.
Pad Seat Back Pocket
Pad Bottom Pocket
