background image

6

•  Locate the battery compartment door on the frame.
•  Loosen the screws in the battery compartment door.
•  Remove the battery compartment door. 
•  Insert four "C" (LR14) 

alkaline

 batteries.

•  Replace the battery compartment door and tighten the screws.
•  If this product begins to operate erratically, you may need to reset 

the electronics. Slide the power switch off and then back on.

•  Low battery power may cause product movement to slow and 

sound volume to become faint or turn off all together. If this 
should happen, please remove and discard all four batteries and 
replace with four, new “C” (LR14) 

alkaline

 batteries.

Battery Installation

Battery Safety Information

Hint: 

We recommend using 

alkaline

 batteries for longer battery life.

1,5V x 4

“C” (LR14)

Battery Compartment Door

In exceptional circumstances, batteries may leak fluids that 
can cause a chemical burn injury or ruin your product. To avoid 
battery leakage:

•  Do not mix old and new batteries or batteries of different types 

alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

•  Insert batteries as indicated inside the battery compartment.
•  Remove batteries during long periods of non-use. Always remove 

exhausted batteries from the product. Dispose of batteries safely. 
Do not dispose of this product in a fire. The batteries inside may 
explode or leak.

•  Never short-circuit the battery terminals.
•  Use only batteries of the same or equivalent type as recommended.
•  Do not charge non-rechargeable batteries.
•  Remove rechargeable batteries from the product before charging.
•  If removeable, rechargeable batteries are used, they are only to be 

charged under adult supervision.

•  Protect the environment by not disposing of the product with 

household waste (2002/96/EC). Check your local authority for 
recycling advice and facilities.

Summary of Contents for M6711









Reviews: