4
•
"Snap"
the tabs on the lower track into the slots in
the base.
Lower Track
Assembly
• Press the clamp on the track support onto the
base column.
• Rotate the track support so that the holes in the
support fit over the pegs on the lower track.
Track Support
Clamp
Column
5
6
Pegs Through Holes
• Place the garage on its side on a flat surface, as shown.
•
"Snap"
the rectangular connectors on the upper track into
the holes at the top of the base.
• Fit the other end of the upper track over the end of the
lower track.
• Place the garage upright again.
• Insert two
1
/
2
"
screws into the holes on the underside of
the upper track, as shown. Tighten the screws.
Upper Track
7
• Tip the elevator handle and fit the hooked tab through the
channel in the side of the elevator
.
• Slide the elevator handle down and
"snap"
the tab on the
handle into the slot in the elevator
.
Hooked Tab
Channel
Slot
8
Elevator
Handle
