background image

6

Battery Installation

•  Loosen the screw in the battery compartment door. Remove the 

battery compartment door. 

•  Insert one “D” (LR20) 

alkaline

 battery into the battery compartment. 

•  Replace the battery compartment door and tighten the screw.
•  Pull and fit the pad seat bottom pocket around the soothing unit 

and footrest.

•  If this product begins to operate erratically, you may need to reset 

the electronics. Slide the power switch off and then back on.

2

Hint:

 We recommend using an 

alkaline

 battery for longer 

battery life.

+

1,5V

“D” (LR20)

•  Pull to remove the pad from around the retainers and the 

soothing unit 

A

.

•  Remove the pad bottom pocket from the footrest 

B

.

1

Protect the environment by not disposing of this product with 
household waste (2002/96/EC). Check your local authority for 
recycling advice and facilities (Europe only).

B

A

A

In exceptional circumstances, batteries may leak fluids that can 
cause a chemical burn injury or ruin your product. To avoid
battery leakage:

•  Do not mix old and new batteries or batteries of different types: 

alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

•  Insert batteries as indicated inside the battery compartment.
•  Remove batteries during long periods of non-use. Always remove 

exhausted batteries from the product. Dispose of batteries safely. 
Do not dispose of product in a fire. The batteries inside may 
explode or leak.

•  Never short-circuit the battery terminals.
•  Use only batteries of the same or equivalent type as recommended.
•  Do not charge non-rechargeable batteries.
•  Remove rechargeable batteries from the product before charging.
•  If removeable, rechargeable batteries are used, they are only to be 

charged under adult supervision.

Battery Safety Information

Summary of Contents for T4144









Reviews: