Model: 29801 Spring Driven Hose Reel
Model: 74988 Reel Kit Pro Spray Valve
Page 2
Item #
Description
# Req.
29801
2980-R027
75079
9
Bumper Stop Assembly
1
10
Hose Assembly
1
14
Drive Spring
1
31
Swivel Assembly
1
32
Swivel Union
1
Hose I.D. and Length
3/8” x 30 FT
Reel Inlet Connection
3/8” F.P.T.
Max. Operating Pressure
200 P.S.I.
Max. Operating Temperature
160 °F
Item #
# Req.
Description
Item
# Req.
# Part
Description
Item # # Req.
Description
Item # # Req.
Description
1
2
1” Snap
31
1
75066
Hose RR 3/8m x 1/2f x 1 1/2 ft
32
1
2980-R020
Tube vinyl clear 6 inch
33
1
2913-3/8
Handle 3/4-14f X 3/8f
34
1
2922-5000
Gasket Handle
35
1
2990
Pro Spray Valve
36
1
3298
PST Thread Sealant
Ring
11
1
Guide Arm Assembly
21
1
Latch Bushing
2
2
Spacing Washer
12
1
Base Assembly
22
1
Latch Spring
3
3
1/4-10 x 5/8”
Self Tapping Screw
15
1
Spring Case Stud
24
1
O-ring
4
1
Sheave Flange
16
1
3/8-16 x 1/2” Set Screw
25
1
Latch Plate Assembly
5
1
Sheave Disk
17
1
Spring Case & Hub Assembly
26
1
10-32 x 1” Machine Screw
6
1
Latch Cam
18
8
10-32 x 3/8” Nyloc Nut
27
1
U-bolt Hose Clamp
7
2
Spring Arbor
19
1
Latch Plate Bumper
28
2
1/4-20 Nyloc Nut
8
7
10-32 x 1/2” Machine Screw
20
1
10-24 x 3/8”Self Tapping Screw
30
1
Main Shaft
31
32
33
34
35
36
1. Connect the lead-in line (31) to the reel (29801) inlet located on the right-hand side of the hose reel,
by appling PST (36) or plumbers tape on the male 3/8” NPT threads on the lead-in line (31) and thead it
to the reel (29801) using a wrench to support the swivel while tightening the lead-in line.
2. Connect the 1/2” female end of the lead-in line (31) to the water supply using PST (36) or plumbers tape
and tighent.
3. Turn on water supply and flush the reel line to remove any debis from the reel for a few seconds and
then turn off water supply.
4. Slide the clear vinyl tube (32) over the reel hose up to the bumper (9).
5. Attach the handle (33) to the reel hose (10). By appling PST (36) or plumbers tape on the 3/8” NPT male threads on reel hose
and tighen.
6. Insert the gasket handle (34) into the handle (33) and then connect the pro spray valve (35).
7. Turn water supply on and check for leaks.
NOTE:
Apply PST or Plumber Tape on
the following locations to prevent any
leaks.
1
1
1
