Lit. No. 94196/94197/94198, Rev. 05
13
November 1, 2010
MOUNTING THE SPREADER
7. Tip the spreader toward the truck until the sill rests
on the rear edge of the truck bed.
8. Lift the rear of the spreader and slide it into the
truck bed. Two or more people are recommended
for this task.
9. Center the spreader in the truck.
10. Remove the cable tie holdling the wire harness
to the conveyor chain. Connect the vehicle side
harness to the hopper side harness.
11. Assemble the material de
fl
ectors to the sill.
a. Loosen both carriage bolts for the bearing and
the last two cap screws for the gearbox.
b. Slide the de
fl
ectors into place between the sill
and the fastener heads.
c. Tighten all of the fasteners according to the
torque chart.
NOTE: The de
fl
ectors must be removed if you are
going to store the unit vertically.
Loosen both
carriage bolts.
Loosen last two
cap screws.
Retighten
fasteners
